Shiling BYD clean forklift after-sales, dust system regular maintenance instructions

Shiling local warehousing, light industry gathered, daily operation scene floating fine dust more, clean electric forklift dust system, is an important protective structure to block dust into the motor, electronic control, battery compartment and other core components, regular compliance maintenance, is the core link to ensure long-term stable operation of equipment.

Many users are prone to neglect the daily maintenance of the dust protection system, allowing small problems such as clogging of the dust cover and cracking of the sealing strip to exist for a long time. After the dust enters the core cavity, the heat dissipation efficiency of the components will decrease, and the dust attached to the line will accelerate the aging, which will not only unnecessarily increase the probability of failure, but also shorten the normal service life of the core components, adding unnecessary operation and maintenance costs.

Starting from the actual operation scenarios in the Shiling area, the after-sales team has set up a hierarchical maintenance cycle reference for the dust-proof system: conventional low-load operation scenarios, it is recommended to complete a basic dust-proof special project inspection every 30 working days; high dust operation scenarios, it is recommended to carry out a rapid investigation every 15 working days; every 6 months, it is necessary to cooperate with the after-sales staff to complete a system-wide deep maintenance.

Standardized after-sales dust protection system maintenance process is divided into several steps, the first is the appearance of the initial inspection link, maintenance personnel will first intake dust cover, the sealing strip at the connection of each cabin to clean the outer layer of dust, one by one to check whether the strip is cracked, deformed, whether there is a large area of foreign body blockage, found damaged parts will be marked as soon as possible.

Next is the filter special project processing, maintenance personnel will be careful to take out the corresponding position of the dust filter, with low pressure air flow to do a comprehensive purge cleaning, if the detection found that the filter is blocked can not be cleaned, there is obvious damage, will directly replace the new original fitting parts, to ensure that the filtration efficiency is always in line with factory standards.

After that, the maintenance personnel will conduct a re-test of the sealing of all the joints of the cabin to confirm that there is no misalignment or leakage of all sealing points, to ensure that the tightness of the protective structure meets the requirements, and finally power on the whole machine for operation testing. After confirming that the air intake and sealing status of the dust protection system are all up to standard, the equipment will be delivered to the user for use.

During daily use, the user can also cooperate with simple basic maintenance. After each operation, the dust attached to the surface of the dust cover can be wiped off at will. Do not disassemble the sealing protective structure set by the original factory without permission. If the vehicle power output is found to be abnormal during daily operation, and there is an abnormal sound at the air outlet of the heat dissipation port, you can directly contact the local after-sales maintenance site in Shiling to arrange on-site inspection to avoid small problems from dragging into major failures. Long-term adherence to standardized regular dust maintenance can effectively reduce the situation of unplanned downtime of equipment and provide reliable operation support for daily handling operations.